Southeast Michigan Woodworkers

Gather, share, learn and enjoy with other woodworkers!
It is currently Sun Oct 22, 2017 4:54 pm

All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Wed Aug 30, 2017 8:42 am 
Offline
Journeyman

Joined: Fri Dec 12, 2008 7:36 am
Posts: 59
I am currently building a small cabinet for my Tormek I have put the laminate on the countertop portion and have trimmed it with 3/4" red oak I would like to chamfer the edge and since I've done this once but it was 8-9 years ago and I don't remember what I did. My gut tells me to first trim the laminate flush with a laminate trimmer bit and then follow up with the chamfer bit to get the 45 degree edge As I have built this with all scrap material and don't enough left in case of a screw up I wanted to make sure I do it correctly

thanks


Top
 Profile  
 
PostPosted: Wed Aug 30, 2017 12:56 pm 
Offline
Elite

Joined: Tue Oct 27, 2009 9:14 am
Posts: 1373
You can do what you describe, but I am sure you can get a laminate trimming bit with the angle built in.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 0 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron

Forum hosting by ProphpBB | Software by phpBB | Report Abuse | Privacy