Southeast Michigan Woodworkers

Gather, share, learn and enjoy with other woodworkers!
It is currently Tue Oct 17, 2017 2:44 pm

All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 4 posts ] 
Author Message
PostPosted: Mon Aug 07, 2017 8:04 pm 
Offline
Elite

Joined: Tue Dec 18, 2007 7:15 am
Posts: 1078
Location: Manchester
Hello i baven't postef in awhile, hope all is well wth everyone. I acquired a nice planer and this is my first real planer, been using a lunchbox model. First time adjusting knives and rollers (newby) Question 1. I don't have ripples in the wood so i know (think) the depth is good. No burrs on the knives but i am getting lines (tiny ridges) down the length of the board which i would think would be caused by burrs. What is the cause? Question 2. The instructions state to adjust the outfeed roller 0.010 less on one end than the other end. Why not even on both ends? I had a devel of a time adjusting the knives, couldn't see around the adjusting gauge well enough (old eyes?) so i made a new smaller one out of oak at it appears to work.


Attachments:
IMG_0987.JPG
IMG_0987.JPG [ 1.2 MiB | Viewed 213 times ]
IMG_0986.JPG
IMG_0986.JPG [ 1.23 MiB | Viewed 213 times ]
Top
 Profile  
 
PostPosted: Tue Aug 08, 2017 9:07 pm 
Offline
Apprentice

Joined: Sun Aug 07, 2011 7:41 am
Posts: 40
Ridges down the length of the boards indicate a nick the knives. You can shift them to the left and right a little bit so the nicks no longer line up and the ridge will go away.


Top
 Profile  
 
PostPosted: Tue Aug 08, 2017 9:41 pm 
Offline
Master

Joined: Tue Mar 08, 2011 1:37 pm
Posts: 172
Location: Manchester, MI
Wow that's a big planer, or is it the picture....


Top
 Profile  
 
PostPosted: Wed Aug 09, 2017 3:53 pm 
Offline
Master

Joined: Mon Feb 13, 2006 2:22 pm
Posts: 267
Location: Raleigh, N.C.
Jerry:

The problem is nicks in the blades. As suggested, you can offset the 3 blades but since you will have to reset them anyway, you might as well take them out and send them out for re-sharpening.

Be careful as I believe there are small springs under the ends of each blade.

The DC-33 is an excellent tool and I used mine for over 30 years before selling it and getting a wider planer.

Good Luck
David Turner
North Raleigh, NC


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 4 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  

Forum hosting by ProphpBB | Software by phpBB | Report Abuse | Privacy